Gasoline Siphone Hose, Gas Oil Water Fuel Transfer Siphon Pump, Portable Widely Use Hand Fuel Pump, Fuel Transfer Pump with 2 Durable PVC Hoses

Description You needn’t have to start the siphoning process with your mouth next time. Excellent Siphon Hand Pump! which is a perfect must-have for your motorcycles, scooter ATV,brush cutter, lawn Mower, snowblower, hedge trimmer, etc.Sometimes you let them sit too long, the gas goes bad……It will transfer up to 3.5 gallons liquid per minute. This inexpensive tool will save you a trip to the machine mechanic and you will have your engine running. To be reliable driver,This can save you on emergencies, especially during long drives. You also need a basic siphon to drain gas from equipment such as: lawn tractor, lawn mower, snow blower, wood splitter and generator. And our siphon pump will worked perfectly for removing and changing the gasoline in your lawn mower ,snow blower ,instead of tipping the machine… Gravity Required   The source fluid should be higher 11 inch or more than the target one (The greater the height difference, the better the effect). Put a clip on one end of each hose, then connect the hoses to both end of the pump bulb. Secure the end of hose and pump bulb with clip, make it won’t flop out or leak fluid. Put the input hose into the source fluid, the black arrow which on the pump bulb points to the exit flow direction. Then squeeze the pump bulb 3 to 4 times. When the liquid comes close to the pump bulb, place the outlet hose into the target container. Then the liquid will keep flowing naturally. When the fluid level is too low at the bottom of the source container, the pressure will not enough to keep fluid flowing naturally, then need to keep squeezing the pump bulb with hand to finish the pumping job.   No Gravity Required   There is no height difference required between the source container and target container. Put a clip on one end of each hose, then connect the hoses to both end of the pump bulb. Secure the junction of hose and pump bulb with clip, make it won’t flop out or leak fluid. Put the input hose into the source fluid, the black arrow which on the pump bulb points to the direction of flow. Then squeeze the pump bulb 3 to 4 times. When the liquid comes close to the pump bulb, place the outlet hose into the target container. Then keep squeezing the pump bulb continually with hands to control the flow rate, till the transfer job done.   Self-check Points When Siphon Pump Can’t Work Normally The source container which you want to get rid of fluid is placed HIGHER than the target container when using the “Gravity Required” way. Both of the source container and the target one are not in a sealed state. The indicator arrow which on the pump bulb towards to the exit flow direction, down to the target container. Both of the hoses are not knotted or twisted together. Exhaust the gas out from the hoses before using. Keep the end of the two hoses inside the containers during using, NOT just on the surface.   What You Get Pump Bulb x1 Hose(31” / 47”) x2 Metal Clip x2 Hose Retainer x1